Hi Justin, I sure hope your V12 doesn't use GPM. If so you might as well fill the back seat with fuel tanks. The pump should be rated at a fuel pressure. Usually 3 to 4 Psi. is sufficient. Beware of too much pressure. The pressure should be checked at the carbs. going down the road at say 50 MPH. Usually a gear rotor pump is best because it doesn't have any rubber parts that could be effected by ethanol. If you go on line and check out gear rotor pumps you will find many to chose from.
Cordially Mike
I am using a Carter P60504 12V pump running on 6V on the Cord. I am using the same pump on a 1913 Stevens Duryea running on 12V. On the Auburn I am using a Airtex 6V pump E8011 with a 3 lbs. pressure regulator, with the inlet and outlet valves removed from the fuel pump. I have 2 1/2 lbs. pressure at the carb. at 60 MPH and 2 lbs. on acceleration.
Cordially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
