The secret to getting it to fold relatively flat is to not nail or staple the top pads to the center box that crosses between the center door post (hinge pillar). Upholsterers see that the bow has a tack strip in it and then go nail the pads to such (it has a tack strip only because they made all the bows the same - not to tack to it). The center bow slides behind the rear door pillar bow when you put the top down - ie the pad would not allow this functionality if nailed to the center door post bow.
 
Also, I find it easier to leave the center door posts in the car when putting the top down - gives you a place to sit it when you bind something up.
 
And, takes 2 people (one on each side) - and a trained monkey.
 
Also, the mechanism around the center door post has plenty of sharp corners - I wrap in a towel when down (this would be in the area of enter of back seat when down).
i have recently purchased a 1935 851 Phaeton. i see that you were able to obtain instructions for putting the top down. Could you please forward them to me as well?
Vic Trino
I have been putting ours down as follows:
Roll down the windows
Open rear doors to point of being unlatched
Unsnap the top on both sides.
Fold the rear window down into the top well/tray
Remove all the upper thumb screws around the center door pillars, but leave the lower pillar screw in and leave posts on. Loosen the windshield thumbscrews.
Lift top over the windshield pins
Scissor top to inside and pull all fabric up and out of way, while a person is on right and a person is on left side of car
There is a note about pads being nailed to center cross bow - if nailed to you will never get it to fold right.
Slide the top mechanism from sides to then be in the middle and ... behind the major bow at rear doors.
Reach in and unlatch landau irons and then fold the rear of top.
Wrap the mechanism that is at center door posts which is now in center of the pile of top (ie lots of little sharp points around this area).
Install boot
Remove the center pillars (I leave them in until end as if you get stuck in process you can gently rest mechanism on a post while figuring out your geometry.
Store all top thunbscrews parts in glove box or rear door pockets
You probably need a bag for the center posts - they are hollow and dent easily. (I store in trunk and do not recall if they fit in glovebox or not).
 
Up is the reverse and just be careful not to force anything and you have to watch close
 
By the way, the top was designed to be one man put down - (that is Curt's factory instructions and it can be done).
John, I appreciate your detailed instructions. It would be a real trick for one person to put the top down. Thanks for the help.
Vic Trino
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


