OK, I tried something yesterday and I got some strange results.
 
It was about 80 degrees out and I disconnected and plugged the vacuum advance port in the manifold. We took it for a drive through the neighborhood and when we were cruising at 25 it ran 205 or 210, when we were under load up hill it dropped to 195 but when we were down shifting going down hill under no load it ran back up to 210-212.
 
I checked the vacuum set up on the distributor and it looks like at full vacuum it retards the ignition. I have had some guys look at it and say it should not have full manifold vacuum so I am looking for some guidance form anyone who is familiar with this conversion.
 
I am still thinking it has something to do with the timing but have not ruled out a radiator issue.
 
Has anyone had a custom radiator built with extra cores for cooling capacity or aluminum technology?
They should run about 160. You probably have multiple problems. For one thing you have a unknown dist. By that I mean you don't know how many degrees it advances or retards. Is the dist. made to rotate the direction your Auburn motor needs or is rotating backwards? If it is rotating backwards it would not advance. Get the proper dist. Is your water pump impeller turning? Shaft can be turning but not impeller. Is your lower radiator hose collapsing? Does it have a spring inside? Is your radiator and block clean? Are you using water with anti corrosion inhibitor or antifreeze? Water cools better. Is your timing set correctly? Is the TDC mark actually at TDC? Alum. radiator will only try to cover up your other problems and probably not solve anything other than emptying your wallet. Good luck. Dist. would be most likely culprit in my opinion.
Cordially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
