It is always fun to see parts cars,and especially cars that were exported.
 
"If only they could talk"
You are an inspirational person, thank you for showing your site of your 32 Auburn sedan. It just goes to show if you have the determination and know how and know what you want or picture the end results nothing is impossible. Your site is very useful with a lot of tips. I will use your tip on the rear springs on my 35/36 straight eight. Unfortunately im not as good as you at mechanical work.
I'm only good at collecting but not bad at woodwork, so hopefully in a year i will post my straight eight with a 36 boatail wooden buck on it. Im glad you liked the picture of my parts car. Happy collecting.
Hey Chris:
Good luck with the sale of your six cylinder parts. You may want to put an auction up on the Down Under version of eBay as well. It may also be a good idea to go into that dual ratio and determine if it still has all the internal pieces in the right places. 6 cylinder DR's are the same as 8's except for the axle 1/2 shafts,bearings & seals.
Curt, Are the bearings and seals different because the axles are smaller in Dia.? I presume the axles are not shorter because then the housing would be different also.
Cordially Mike
Mike, yes the OD of the axles are smaller, otherwise it is the same diff. There is an early and late style of Dual Ratio the change over was in 2/35, this is an early style.
 
Chris, I am [i:2mzdf0hh]almost[/i:2mzdf0hh] sure it is a six, from the appearance of the brake drum. The brake hardware is not considered a part of the diff. Be sure all of the teeth are on the ring and pinion. Also look in the center section in the planetary and inspect for cracks. See att pix.
 
I get a HTTP error and can not post pix on this site. 330 KB should not be too big. FRUSTRATING!!
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
