David
 
All of the fittings I have seen are male SAE flare fittings or compression sleeve fittings. No inverted flares( unless those are on the hydraulic brakes lines )
Interesting sleuthing!
So if Auburn was trying to follow the fastened decoder format for lines, then the first number after the dash is the pipe diameter in 16th's and the next three digits are the pipe length in 1/2ths.
 
2S-5014 - fuel pump to carb line is 5/16th x 7 inches long
2S-3076 - oil filter to inlet tube is 3/16th x 38 inches long
Which is what the parts manual says!!! Never noticed that before, interesting observation!
Can't quite get to the same place as you did with the fittings in the 1931 parts book as they are all two digits after the dash only.
All bets are off for the Bijur system which uses 5/32 line
 
Now if you can sort out the secret decoder for the SZ fasteners, you'll be ready for Bletchley Park!!!
 
Brad
Thank you Brad, that's a big help! It's a strange code but seems to work. I liked the Bletchley Girls tv shows.
Dave
I wanted to ask about the vacuum line for the two speed rear end. At the intake manifold' date=' my car has an inverted flair fitting going into the square three way block. What should the fittings on the shut off valve and the switching valve be? Also, was the three way block painted with the manifold or was it installed later and left brass color? Thanks Dave[/quote'] 
Dave, I am no expert on 31-33 cars. On 34's with free wheeling, the fittings were natural and all were 7/16 inverted flair.
Thank you Curt,
I'm going to go with that.
Dave
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
