Randy
 
As I understand it, they have both the automatic advance (centrifugally operated spring weight system in distributor) and the manual control on the dash.
Was the dash spark control just there to balance out the dash arrangement or did it actually serve some purpose 😁 .
If I my understanding of the operation of the system correct, then all I can think of is that it's function is solely to manually retard the spark to allow for safe hand cranking of the motor. I just think it odd that the manufacturer would supply a knob and offer no advice on what it is there for. Perhaps we are too accustomed to 200 page owner manuals that describe what a door handle is for!
 
Brad
My L-29 Cord has the same setup. I retard the spark for starting and then advance it and leave it alone.
Cordially Mike
Mike
 
Does any of the Cord literature offer an explanation of the usage? I'm pretty sure I get it but I am still curious about the lack of any 'official' description since the Auburn manuals did cover the rest of the controls.
In keeping with your comments,
I did find this comment in the 11/64 club newsletter article on V12's
gauge, and water temperature gauge. Controls included the throttle and choke, manifold heat control and a spark control to retard the spark from the setting of the automatic advance mechanism. These
engines start easier if the spark is retarded.
And this from the 7/81 newsletter on L-29's
D) Ignition Timing: Spark control full advance
(pushed IN) Distributor set so contact points are just
breaking for #1 All engines are set at 12┬░ to 15┬░ BUDC,
or 4 to 5 teeth before flywheel is at top dead center.
Just nothing from the factory!
 
As a word of caution for anyone trying to use the 1927-1941 National Service Manual available on this website http://restorecarsclassifieds.com/wiki/ ... .php?n=249 ( which is an interesting website with some really good scanned information) the procedure for setting the timing for 1931 is wrong and the procedure for 1932 is correct as far as positioning the distributor goes! Thus my head scratching! Too much internet isn't necessarily a good thing especially if it involves bad information from 1941!
 
Brad
Brad,
In looking at two different Auburn operating manuals (1926 8-88 and 1930 8-125)
under operating instructions, starting the engine......both manuals state to "retard spark lever (left lever on steering post) by drawing it halfway down"
After engine starts, advance spark lever upward as far as it will go (driving position).
 
Mike's L-29 is essentially the same as the Auburn 1930 8-125
 
Joel
Here is the info. from the A.E.A. Tune-Up Chart. "Stationary breaker contacts to open at 12 1/2 degrees (3 1/4 flywheel teeth) before top dead center for No. 1 cyl. Manual spark lever fully advanced" Manual advance is 7 1/2 distributor degrees. Automatic advance is 13 1/4 at 1300 distributor degrees. Remember distributor degrees and distributor RPM's are 1/2 engine RPM and degrees! Before doing all this make sure the points are synchronized. They are synchronized at 45 distributor degrees. Breaker gap .018 to .024. Dist. machine is best choice but syn. tool also work relatively well if done carefully. Good luck.
Cordially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
