Freshly rebuilt engines are tight, and this brought out an underlying problem.
I suspect that you have a grounding problem.
The cables should be at size 00 or better. Do the early cars have lead washers between the cable and the frame? On 34-36 cars there is an additional ground strap from the starter to the frame. Is the starter motor to the bell housing clean. Lastly and very important, the grounding brushes need to be grounded directly to the starter motor frame. Not through the rivet in the end plate. Typical re builders replace the bearings, brushes and install a new bendix. The grounding brushes will ohlm out just fine untill there is 600+ amps trying to find their way home.
 
My experience is with 34-36 Auto-Lite starters not the early Delco's, but the principal is the same. 9 out of 10 electrical problems with old cars is poor grounding.
Hello Michael,
From my experiance rebuilt car and motorcycle engines turn over easier when they are hot due to the oil being less viscous and the components at their correct operating clearances . I suggest you turn the engine over with the hand crank with the engine cold then hot and compare the difference, you may need to remove the plugs. This will help eleminate any possible starter motor problem that may be accuring when the starter motor is hot. If your engine is that tight you will not be able to turn it over with the hand crank even with the plugs removed. If it is the engine then possibly a component has not been given the correct clearance.
Mike,
You were talking about putting in a new radiator with a modern core, did you? I would have thought that would have solved your problem.
Frank
Rework the grounds on the starter brushes
Clean up the mating surfaces of the starter
Clean up the mating surface of the starter to block - ie remove all the pretty shiny thick paint.
Then make sure you have good ground of the starter to the frame
And then also add in a ground from the engine block to the frame.
And, I love my Optima battery, though they are difficult to charge when they get a low charge.
Rework the grounds on the starter brushes
Clean up the matting surfaces of the starter
Clean up the matting surface of the starter to block - ie remove all the pretty shiny thick paint.
Then make sure you have good ground of the starter to the frame
And then also add in a ground from the engine block to the frame.
And, I love my Optima battery, though they are difficult to charge when they get a low charge.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
