I will tell you how I handle me fuel delivery on my 31 Cord which uses a Schibler Carb. Depending on the model 29 you have it might have this carb. also.
I use a rotary fuel pump No. P60504( a NAPA No.) This is a 12V pump but I run it on 6V and it puts out 2 1/2 pounds pres. which is all the pressure you need. This pump should be mounted as close to the tank as possible. I then remove the arm on the mechanical pump, put a blocking plate between the mech. pump and the block. I run the fuel through the mech. pump just as you would a working pump. I run the electric pump all the time and the mech. pump is only a dummy pump. Because the rotary pump does not have a dia. there is no problem with alcohol attacking it. I also have a pressure switch on the oil pressure line going to the oil pressure gauge. This switch is in the circuit to the fuel pump. If I loss oil pressure the fuel pump will shut off, as a safety measure.
As far as brakes are concerned all inner components are available from NAPA. If you don't drive the car much the alum. pistons can corrode in the wheel cyl. even with silicon fluid. They advise pushing on the brakes one an a while to avoid this.
CORDially Mike
Interesting idea, Mike, using a 12v pump on 6v. My Cord uses a similar (Carter) rotary pump. I've always used the 6v unit, and I need a regulator at the carb to keep the pressure down. Does the pump function reliably? Have you ever felt it to see how hot it was getting?
 
Keep the good ideas coming!
Josh,
I talked to Carter eng. about running a 12V pump on 6V and he told we that this pump ran on 6V would run forever. He said it was designed as a 6V pump to start with. I have never felt it to see how hot it gets. It must be used with a filter before the pump because of very close tolerances internally.
CORDially Mike
Hi!
I found running the auto-pulse and the mechanical in my 812, they will give plenty of fuel and can run on either one alone, I was considering a fuel regulator. I use a cut off electric switch on dash once its running. The engine can be very difficult to start after prolonged running, possibly from rich mixture, just baffles me. I have found in the prewar cars the pumps are fine except the alcohol will remove the shellac that they used to coat the carb floats and gaskets on assembly. They and the auto-pulse will leak with 10% alcohol, I have also seen carb floats dipped with paraffin repairs. If the pumps are disassembled and modern gasket sealers are used and the diaphragms are not perforated, they should be reliable. Also it is important to check the float needle & seat.
Try a Air-Tex E8902 that puts put 2 to 4 PSI. That is a gear rotor pump that will not have a problem with ethanol fuel. The thread you are addressing is from 2006 and I regret to say some of the previous responders are no longer with us.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
